****新闻

首页 > ****新闻
在施工时路沿石模具有什么要求
发布人:管理员   发布时间:2020-12-15

路沿石模具是在路面上区分车行道、人行道、绿地、隔离带和道路其他部分的界线,模具专业生产预制混凝土路牙,道牙,路侧石,路肩板等。
Curb stone mold is the boundary line that distinguishes the roadway, sidewalk, green space, isolation belt and other parts of the road on the road surface. The mold is specialized in the production of precast concrete curb, curb, curbstone, shoulder slab, etc.

路沿石模具必须挂通线举行施工按侧平面顶面示高标线绷紧,按线码砌侧平石,侧平石要安正,切忌前仰后合,侧面顶线顺直光滑油滑平顺,无崎岖错牙征象,平面无上下错台、内外错牙征象。
The road edge stone mold must hang through the line to carry on the construction, according to the side plane top surface high mark line to tighten, according to the line code to build the side flat stone, the side flat stone must be safe, avoid front and back together, the side top line is straight and smooth, smooth and smooth, there is no sign of uneven teeth, the plane has no sign of upper and lower staggered platform, internal and external teeth.

     

必须座浆砌筑,座浆必须密实,严禁塞缝砌筑;路沿石接缝处错位不高出,侧石宁静石必须在中间匀称错缝。路沿石模具必须人工精凿后抛光处理惩罚。
It must be built with mortar, and the mortar must be dense, and it is forbidden to plug the joint; the dislocation of the joint of the road edge stone is not higher than that of the side stone, and the side stone and quiet stone must be evenly staggered in the middle. The mold of curb stone must be polished after manual chiseling.

路沿石模具背面应还土夯实,夯实宽度不小于厚度不小于路沿石勾缝:勾缝时必须再挂线,把侧石缝内的杂物剔除干净,用水润湿路侧石模盒,然后用路沿石勾缝、安砌后恰当浇水养护。
The back side of the road edge stone mould should be rammed with soil, and the tamping width should not be less than the thickness and the joint of the road edge stone. During the jointing, the line must be hung again, the sundries in the side stone joint should be removed, the roadside stone mold box should be wetted with water, and then the road edge stone should be used for pointing, and the proper watering and curing should be carried out after the installation.

 

上一篇:没有了