路沿石模具想要在使用过程中更合理、更****的使用路沿石模具。防止碰撞,路沿石模具表面覆盖着一层胶衣树脂,硬度虽然很大,但不足以承受一些尖锐物体的碰撞,路沿石模具使用和放置的过程中,应注意避免被其他物品硌伤。
More reasonable use of molds along the stone road. To prevent collision, the surface of curb stone mold is covered with a layer of gel coat resin. Although the hardness is very large, it is not enough to withstand the collision of some sharp objects. Attention should be paid to avoid being hurt by other objects during the use and placement of the mold.

确保路沿石模具表面没有硬的石膏粉凝结渣,确保使用的石膏粉中没有杂质,防止残渣划伤路沿石模具表面。路沿石模具中的泥料凝结后,应迅速脱模,不要长时间放置在路沿石模具上,容易使水分被挤入路沿石模具表面,产生鼓泡。
Ensure that there is no hard gypsum powder coagulated slag on the surface of the road edge stone mold, and ensure that there is no impurity in the gypsum powder used, so as to prevent the residue from scratching the surface of the road edge stone mold. After the mud in the mould of curbstone is condensed, it should be demoulded quickly. It is not allowed to place it on the mould for a long time. It is easy for moisture to be squeezed into the surface of the mould and produce bubbles.

路沿石模具使用完毕后,应涂上一层脱模剂进行保养,路沿石模具使用一段时间后,表面受到了一定的损伤,这时,路沿石模具表面就容易出现一些石膏粉的残留粘附在路沿石模具表面,影响生产的路沿石的表面光滑度,
A layer of release agent should be coated on the surface of curbstone mold for maintenance after it is used for a period of time. At this time, the surface of the mold will be damaged to some extent. At this time, some residual gypsum powder will adhere to the surface of the mold, which will affect the surface smoothness of the produced curbstone,

遇到这种情况,不要用硬物刮拭,要用滚烫的开水冲洗,很容易就冲掉了,把路沿石模具冲洗干净并晾干后,涂上一层脱模剂,保养一段时间,情况能略好转一些。
In this case, do not wipe with hard objects, but wash them with boiling hot water, which will easily be washed off. After washing and drying the molds, apply a layer of release agent and maintain for a period of time, the situation can be slightly improved.